|
|
- /*
- 【花雕動手做】超低成本，嘗試做個五十元的麥克納姆輪小車！
- 實驗接線方法：
- MX1508模塊 Ardunio Uno
- GND---------GND接地線
- VCC---------5V 接電源
- IN1---------D6
- IN2 ------- D7
- IN3---------D8
- IN4 ------- D9
- IN1---------D10
- IN2 ------- D11
- IN3---------D12
- IN4 ------- D13
- 程序之一：簡易控制麥輪小車前進與后退
- 電機正轉3秒,停止1秒，反轉3秒，停止1秒，循環
- */
- void setup() {
- pinMode(6, OUTPUT);
- pinMode(7, OUTPUT);
- pinMode(8, OUTPUT);
- pinMode(9, OUTPUT);
- pinMode(10, OUTPUT);
- pinMode(11, OUTPUT);
- pinMode(12, OUTPUT);
- pinMode(13, OUTPUT);
- }
- void loop() {
- digitalWrite(6, HIGH);
- digitalWrite(7, LOW);
- digitalWrite(8, HIGH);
- digitalWrite(9, LOW);
- digitalWrite(10, HIGH);
- digitalWrite(11, LOW);
- digitalWrite(12, HIGH);
- digitalWrite(13, LOW);
- delay(3000);
- digitalWrite(6, LOW);
- digitalWrite(7, LOW);
- digitalWrite(8, LOW);
- digitalWrite(9, LOW);
- digitalWrite(10, LOW);
- digitalWrite(11, LOW);
- digitalWrite(12, LOW);
- digitalWrite(13, LOW);
- delay(1000);
- digitalWrite(6, LOW);
- digitalWrite(7, HIGH);
- digitalWrite(8, LOW);
- digitalWrite(9, HIGH);
- digitalWrite(10, LOW);
- digitalWrite(11, HIGH);
- digitalWrite(12, LOW);
- digitalWrite(13, HIGH);
- delay(3000);
- digitalWrite(6, LOW);
- digitalWrite(7, LOW);
- digitalWrite(8, LOW);
- digitalWrite(9, LOW);
- digitalWrite(10, LOW);
- digitalWrite(11, LOW);
- digitalWrite(12, LOW);
- digitalWrite(13, LOW);
- delay(1000);
- }
|
|
小車匯總成本共計53元
